Momogari Carpentry

[Beex]

Would something like this work? I noticed our oven has legs of this type.



CLICK HERE

[Momogari]

Would something like this work? I noticed our oven has legs of this type.



CLICK HERE

Well, yes, that would work. I'd have to get s lot of them though, and then I'd have to adjust each one, which is likely impossible given the dimensions underneath. It would also make installing this thing a lot harder if I can't slide it at all. It's going on carpet.


Top bunk underway.

[Momogari]

[Momogari]

But theres a problem:



The wood. It warp.
I'll just put longass deck screws in from the other side of the 2x4 I guess

[PharaohAtem]

Had that happen with some of the wood for the garden those long nails worked

[Momogari]

Top of the ladder rails hook into a hole on top to make it removeable

[Momogari]

Almost done making all the pieces. Only drawers to do now.

[PharaohAtem]

Looking good

[Momogari]

Drawer pieces cut.

Its 4:30 now. My cutoff today is 6.
I won't make drawers now.
Actually I could probably make the drawers at my own place, as long as all the wood is cut.
I think ots time to move onto sanding.
I will take this thing apart and start sanding each piece in preparation for stain.

[Momogari]

See the quality difference of sanding.
This takes forever for this rough plywood though.

[PharaohAtem]

How many hours have you spent on it so far?

[Momogari]

I don't know, I wasnt counting. At least 25 total. At least 5 just sanding.

I am currently taking it apart, sanding, and staining. I hope to transport at least most of it to my place tonight

[Momogari]

Rounded edge on the desktop

Now to do more on the bottom edge

[PharaohAtem]

Sanding I've found is always the most annoying part

[Momogari]

To solve the load-bearing facade issue, I'm going to just cut the bottoms for now. The piece still won't flex much, but hopefully it can flex enough if theres a problem when I install it.