Poker chairs re-upholstery
Posted: 07 Sep 2020, 21:12
This is what I did this weekend
4 chairs for $20. Very well built chairs--all steel base with wood covering--in good condition except for upholstery that smells like aunt ethel's spittoon.
The bottom cushions were on a piece of plywood screwed down, so we could completely replace the bottom cushion. We bought new foam pads and upholstery fabric for about $80
My mother fitting the first back. The backs we just covered up.
The spindles are slightly small diameter for the base and it was making them unstable so I fixed that.
Cobalt bits. Says they go through stainless steel, but I still ruined three of them.
The duct tape was removed afterwards of course. It was on there temporarily while I tied off the end.
The new fabric was thick and uncompressed. Some forceful persuasion required.
It was more complicated than that of course. Had to redo the shafts like 3 times and trial and error with staples and brads to get the upholstery to sit right.
But I have 4 new chairs.
4 chairs for $20. Very well built chairs--all steel base with wood covering--in good condition except for upholstery that smells like aunt ethel's spittoon.
The bottom cushions were on a piece of plywood screwed down, so we could completely replace the bottom cushion. We bought new foam pads and upholstery fabric for about $80
My mother fitting the first back. The backs we just covered up.
The spindles are slightly small diameter for the base and it was making them unstable so I fixed that.
Cobalt bits. Says they go through stainless steel, but I still ruined three of them.
The duct tape was removed afterwards of course. It was on there temporarily while I tied off the end.
The new fabric was thick and uncompressed. Some forceful persuasion required.
It was more complicated than that of course. Had to redo the shafts like 3 times and trial and error with staples and brads to get the upholstery to sit right.
But I have 4 new chairs.